User Tools

Site Tools


sparkone_wifi_setting

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

sparkone_wifi_setting [2019/11/22 01:00]
peter created
sparkone_wifi_setting [2019/11/22 01:07] (current)
peter
Line 21: Line 21:
   If only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\   If only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\
 \\ \\
-===设置方法2: nmcli===+===Setting method2: nmcli=== 
 + 
 +1. Enter: nmcli dev wifi connect SSID password PWD\\ 
 +   SSID is your wifi name\\ 
 +   PWD is your wifi password\\ 
 +2. After the command is successfully executed, it will be displayed on the SparkOne screen. WIFI:​xxx.xxx.xxx.xxx\\ 
 +3. Unplug the power supply and network cable, and power cycle. After SparkOne connects to the Wifi network successfully,​ the IP address will be displayed on the screen.\\ 
 +   
 +If the only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\
  
-1. 输入指令 nmcli dev wifi connect SSID password PWD\\ 
-   SSID 是你的无线网络名称\\ 
-   PWD 是你的无线网络密码\\ 
-2. 指令执行成功后,SparkOne屏幕上会显示 WIFI:​xxx.xxx.xxx.xxx\\ 
-3. 拔掉电源和网线,重新上电,SparkOne连接Wifi网络成功后,会在屏幕上显示IP地址\\ 
-  如果屏幕上只显示 Wait!,没有出现Wifi的IP地址,请尝试重新执行上述步骤。\\ 
 \\ \\
-===注意事项=== +===Precautions=== 
-如果运行nmcli dev wifi connect指令后,无法连接wifi网络,并提示以下信息\\+If you run the "nmcli dev wifi connect" command, you cannot connect to the wifi network and prompt the following information.\\
   Connection activation failed: (7) Secrets were required, but not provided   Connection activation failed: (7) Secrets were required, but not provided
-请检查你的无线路由器的加密模式是否为 ​WPA-PSK/​WPA2-PSK ​自动模式,将其改为 ​WPA2-PSK ​模式后再次尝试。\\+ 
 +Please check if your wireless router'​s encryption mode is WPA-PSK/​WPA2-PSK ​automatic mode, change it to WPA2-PSK ​mode and try again.\\
sparkone_wifi_setting.txt · Last modified: 2019/11/22 01:07 by peter