User Tools

Site Tools


sparkone_wifi_setting

Spark One connection Wifi network setting method

Ready to work

1. Connect SparkOne and the router with the supplied network cable
2. Plug in the power, wait 30 seconds, the screen displaysETH0: xxx.xxx.xxx.xxx
3. Install software on your computerputty
4. Run putty, enter the ip address displayed on the screen in the host name field, and then clickOpen
5. Enter your user name:root, Password: fa,Enter the management background of SparkOne

Setting method1: nmtui

1. Enter nmtui and press “Enter” to open the NetworkManager management interface.

2. Use the up and down keys to select item 2 in the menu,Activate a connection,Press “enter” to enter

3. Use the up and down keys to select the WIFI network you want to connect to, press the Enter key, enter the WIFI password in the pop-up window, press Enter to confirm

4. After successful execution, SparkOne will display it on the screen. WIFI:xxx.xxx.xxx.xxx
5. Unplug the power supply and network cable, and power cycle. After SparkOne connects to the Wifi network successfully, the IP address will be displayed on the screen.

If only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\


Setting method2: nmcli

1. Enter: nmcli dev wifi connect SSID password PWD

 SSID is your wifi name\\
 PWD is your wifi password\\

2. After the command is successfully executed, it will be displayed on the SparkOne screen. WIFI:xxx.xxx.xxx.xxx
3. Unplug the power supply and network cable, and power cycle. After SparkOne connects to the Wifi network successfully, the IP address will be displayed on the screen.

If the only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.


Precautions

If you run the “nmcli dev wifi connect” command, you cannot connect to the wifi network and prompt the following information.

Connection activation failed: (7) Secrets were required, but not provided

Please check if your wireless router's encryption mode is WPA-PSK/WPA2-PSK automatic mode, change it to WPA2-PSK mode and try again.

sparkone_wifi_setting.txt · Last modified: 2019/11/22 01:07 by peter