skip to content
WEEDO F152 FAQ
Is the filament change operation run once every time you turn it on?
After the model is printed, can I take the model by hand immediately?
What should I do if the bottom of the printed model is not strong or the model is running?
The extruder is clogged or no filament out
Sdcard can't read file
Replace the nozzle
How to solve the slicing program generation gcode is too slow?
Printing model not form
Model warping reason
The machine prints the model height and can only stop printing when it reaches 5cm.
Cleaning the nozzle
· Last modified: 2018/10/28 00:39 by
Back to top
Except where otherwise noted, content on this wiki is licensed under the following license:
CC Attribution-Share Alike 4.0 International